Карты ТВ-тюнера загружены, но не могут настроиться
Я установил две отдельные карты ТВ-тюнера PCI в мой микросервер HP Proliant N40L, работающий под управлением Ubuntu 12.04.2 LTS. Обе карты успешно распознаны и зарегистрированы как карты DVB-T
Попытка использовать утилиты DVB (scan, w_scan) или другое программное обеспечение (TVHeadend) не возвращает сигнал. В dmesg нет сообщений об ошибках (см. Ниже). Одна из карт успешно использовалась в ПК с Windows, подключенным к тому же антенному кабелю, поэтому я уверен, что с оборудованием и сигналом все в порядке.
Каковы следующие шаги для устранения этой проблемы?
[ 10.500910] DVB: registering adapter 0 frontend 0 (Realtek DVB-T RTL2832)...
[ 10.503616] input: IR-receiver inside an USB DVB receiver as /devices/pci0000:00/0000:00:04.0/0000:03:00.0/0000:04:00.2/usb4/4-1/input/input2
[ 10.503795] dvb-usb: schedule remote query interval to 287 msecs.
[ 10.503802] dvb-usb: USB DVB-T Device successfully initialized and connected.
[ 10.503833] dvb-usb: found a 'USB DVB-T Device' in warm state.
[ 10.503844] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
[ 10.507107] DVB: registering new adapter (USB DVB-T Device)
[ 10.529997] RTL2832U usb_init_bulk_setting : USB2.0 HIGH SPEED (480Mb/s)
[ 10.765649] RTL2832U check_tuner_type : FC0012 tuner on board...
[ 10.875461] cx25840 3-0044: loaded v4l-cx23885-avcore-01.fw firmware (16382 bytes)
[ 10.907187] tuner 1-0061: Tuner -1 found with type(s) Radio TV.
[ 10.925702] xc4000 1-0061: creating new instance
[ 10.926262] xc4000: Device not found at addr 0x61 (0xffff)
[ 10.926366] xc4000 1-0061: destroying instance
[ 10.926529] cx23885[0]: registered device video0 [v4l2]
[ 10.926620] cx23885[0]: registered device vbi0
[ 10.926827] cx23885[0]: registered ALSA audio device
[ 10.930850] tuner 1-0061: Tuner has no way to set tv freq
[ 10.942820] cx23885_dvb_register() allocating 1 frontend(s)
[ 10.942824] cx23885[0]: cx23885 based dvb card
[ 10.962568] xc4000 2-0061: creating new instance
[ 10.963291] xc4000: Successfully identified at address 0x61
[ 10.963293] xc4000: Firmware has not been loaded previously
[ 10.971195] DVB: registering new adapter (cx23885[0])
[ 10.971203] DVB: registering adapter 2 frontend 0 (Zarlink ZL10353 DVB-T)...
[ 10.971857] cx23885_dev_checkrevision() Hardware revision = 0xa4
[ 10.971865] cx23885[0]/0: found at 0000:02:00.0, rev: 3, irq: 18, latency: 0, mmio: 0xfe600000
[ 11.332565] DVB: registering adapter 1 frontend 0 (Realtek DVB-T RTL2832)...
[ 11.334180] input: IR-receiver inside an USB DVB receiver as /devices/pci0000:00/0000:00:04.0/0000:03:00.0/0000:04:00.2/usb4/4-2/input/input3
[ 11.334319] dvb-usb: schedule remote query interval to 287 msecs.
[ 11.334324] dvb-usb: USB DVB-T Device successfully initialized and connected.
[ 11.334357] dvb-usb: found a 'USB DVB-T Device' in warm state.
[ 11.334371] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
[ 11.336039] DVB: registering new adapter (USB DVB-T Device)
[ 11.355161] RTL2832U usb_init_bulk_setting : USB2.0 HIGH SPEED (480Mb/s)
[ 11.596933] RTL2832U check_tuner_type : FC0012 tuner on board...
[ 12.163908] DVB: registering adapter 3 frontend 0 (Realtek DVB-T RTL2832)...
[ 12.165480] input: IR-receiver inside an USB DVB receiver as /devices/pci0000:00/0000:00:04.0/0000:03:00.0/0000:04:00.2/usb4/4-3/input/input4
[ 12.165606] dvb-usb: schedule remote query interval to 287 msecs.
[ 12.165613] dvb-usb: USB DVB-T Device successfully initialized and connected.
[ 12.165647] dvb-usb: found a 'USB DVB-T Device' in warm state.
[ 12.165658] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
[ 12.167379] DVB: registering new adapter (USB DVB-T Device)
[ 12.185508] RTL2832U usb_init_bulk_setting : USB2.0 HIGH SPEED (480Mb/s)
[ 12.425785] RTL2832U check_tuner_type : FC0012 tuner on board...
[ 12.995998] DVB: registering adapter 4 frontend 0 (Realtek DVB-T RTL2832)...
[ 12.996640] input: IR-receiver inside an USB DVB receiver as /devices/pci0000:00/0000:00:04.0/0000:03:00.0/0000:04:00.2/usb4/4-4/input/input5
[ 12.997422] dvb-usb: schedule remote query interval to 287 msecs.
[ 12.997428] dvb-usb: USB DVB-T Device successfully initialized and connected.
[ 12.997463] usbcore: registered new interface driver dvb_usb_rtl2832u
вот вывод из lspci:
sudo lspci -v -d 14f1:8852
02:00.0 Multimedia video controller: Conexant Systems, Inc. CX23885 PCI Video and Audio Decoder (rev 03)
Subsystem: LeadTek Research Inc. Device 6f39
Flags: bus master, fast devsel, latency 0, IRQ 18
Memory at fe600000 (64-bit, non-prefetchable) [size=2M]
Capabilities: [40] Express Endpoint, MSI 00
Capabilities: [80] Power Management version 2
Capabilities: [90] Vital Product Data
Capabilities: [a0] MSI: Enable- Count=1/1 Maskable- 64bit+
Capabilities: [100] Advanced Error Reporting
Capabilities: [200] Virtual Channel
Kernel driver in use: cx23885
Kernel modules: cx23885
1 ответ
У меня есть Terratec Cinergy TStick + (ID 0ccd: 00d7).
Кажется, ни один из драйверов брендов / устройств не работает, и вместо этого мне пришлось использовать медиа-сборку
LinuxTV > использовать последние экспериментальные драйверы / патчи
(ссылка содержит шаги для установки драйвера Media Build.)
Что отображается в lsusb с этим устройством на борту?
Можете ли вы предоставить вывод для:
lsusb
lsmod | grep dvb
dmesg | grep dvb